Metrohm 758 KFD Titrino User Manual download pdf (Page 104)

3.2 Remote control commands

758 KFD Titrino

100

In place of "RSX", a result name may be entered (.TextRS). This name is out-

putted in the report full, short, scalc full and scalc srt. It is used for the result

and the corresponding mean value.

The limit control for results can also be activated. If a result is out of limit, a

message appears in the result report, E196 is sent, and output line L13 can

be set.

3.2.2.6. Mode.Def.SiloCalc.Assign.C24 RSX, EPX, CXX

Mode.Def.SiloCalc.Assign.C25 RSX, EPX, CXX

Mode.Def.SiloCalc.MatchId id1, id1&2, all, OFF

.Assign.C2X: Assignment to store results in the silo as C2X.

.MatchId: Indication which sample identification(s) have to match so that

the results can be combined.

3.2.2.7. Mode.Def.ComVar.C30 RSX, MNX, EPX, CXX

Mode.Def.ComVar.C31

etc., up to .C39

Assignment of common variables.

The values of the common variables are to be found in &Config.ComVar. They

can be viewed and entered there, see 3.2.2.80.

3.2.2.8. Mode.Def.Report.Assign1

Mode.Def.Report.Assign2

SET, MEAS: param, calib, full, short, mplist, curve, scalc full,

scalc srt, calc, ff

KFT: param, full, short, mplist, curve, scalc full, scalc srt, calc, ff

CAL: param, calib, full, short, scalc full, scalc srt, calc, ff

TIP: param, full, short, scalc full, scalc srt, calc, ff

Definition of the report sequence, which is outputted automatically at the end

of the determination. Entries of more than one block have to be separated with

";".

.Assign1: Output to COM1 of the Titrino. Identical for COM2.

3.2.2.9. Mode.Def.Mean.1.Assign RS1, RSX, EPX, CXX

Mode.Def.Mean.2.Assign

etc., up to .9

Assignment of the statistics calculations. Valid assignments are a requirement

for statistics calculations. In addition, the statistics calculation must be swit-

ched on, see 3.2.2.26. Rules for statistics calculations see page 46.

3.2.2.10. Mode.Def.TempVar.C70 RSX, EPX, CXX

etc. up to .C79

Assignment of temporary variables in a submethod for calculations in TIP.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 209 210

No comments

Metrohm 758 KFD Titrino User Manual Page 104