Metrohm 758 KFD Titrino User Manual download pdf (Page 107)

3.2 Remote control commands

758 KFD Titrino

103

3.2.2.22. Mode.Parameter.TitrPara.Temp –170.0...25.0...500.0

Parameters for SET, KFT: Titration temperature in °C. If a Pt100 or Pt1000 is

connected, the temperature is measured continuously and the parameter

.Temp is updated.

The temperature is used for the temperature correction in pH measurements.

3.2.2.23. Mode.Parameter.TitrPara.TDelta 1...2...999999

Parameter for SET, KFT: Time interval in s for the entry of a measurement

point in the list of measured points.

3.2.2.24. Mode.Parameter.StopCond.VStop.Type abs., rel., OFF

Mode.Parameter.StopCond.VStop.V 0...99.99...9999.99

Mode.Parameter.StopCond.VStop.Factor 0...±999999

Parameters for SET, KFT: Stop volume.

If an absolute

stop volume (abs.) has been selected, the volume in mL is

valid.

A relative

stop volume (rel.) is dispensed as a function of the sample size:

Stop volume in mL = smpl size ∗ factor

The factor is valid.

OFF means that the criterion is not monitored.

3.2.2.25. Mode.Parameter.StopCond.FillRate 0.01...150, max.

Parameters for SET, KFT: Filling rate in the titration in mL/min. Max. means

maximum possible filling rate with the Exchange Unit in current use.

3.2.2.26. Mode.Parameter.Statistics.Status ON, OFF

Mode.Parameter.Statistics.MeanN 2...20

Mode.Parameter.Statistics.ResTab.Selected original, delete n,

delete all

Mode.Parameter.Statistics.ResTab.DelN 1...20

Entries for the statistics calculations.

.Status: On/off switching. Requirement for statistics calculations is a valid

assignment, see 3.2.2.9.

.MeanN: Number of individual results for statistics calculations.

.ResTab.Select: Selection of the table for the statistics calculations.

original: Original table. The original table is (again) set up, i.e. any

individual results which have been deleted are reincorporated

in the statistics calculations.

delete n: Single result lines are removed from the statistics calcu-

lation. All results of the corresponding line in the statistics

table are deleted. Specification of the line number in

.ResTab.DelN.

delete all: Clear entire statistics table. The results can not be reac-

tivated.

.ResTab.DelN: Specification of the line number to be deleted.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 209 210

Comments to this Manuals

No comments

Metrohm 758 KFD Titrino User Manual Page 107

Comments to this Manuals

Related products and manuals for Equipment Metrohm 758 KFD Titrino