Metrohm 758 KFD Titrino User Manual download pdf (Page 105)

3.2 Remote control commands

758 KFD Titrino

101

3.2.2.11. Mode.CFmla

Mode.CFmla.1.Value 0...±999999

Mode.CFmla.2.Value

etc., up to .19

Calculation constants specific to a method. Stored in the method memory of

the Titrino. Operands specific to the sample (3.2.2.93 and 3.2.2.106) and val-

ues of common variables (3.2.2.80) on the other hand are not stored with the

methods.

3.2.2.12. Mode.Parameter.SET1.EP pH: 0...±20.00, OFF

U, Ipol: 0...±2000, OFF

Upol: 0...±200.0, OFF

Mode.Parameter.SET1.UnitEp read only

Parameters for SET: Setting the 1st endpoint as pH value, in mV (with U and

Ipol) resp. µA (with Upol). The corresponding unit can be read with .UnitEP.

If the value is on "OFF", no further nodes will appear from SET1.

3.2.2.13. Mode.Parameter.SET1.Dyn pH: 0.01...20.00, OFF

U, Ipol: 1...2000, OFF

Upol: 0.1...200.0, OFF

Mode.Parameter.SET1.UnitDyn read only

Mode.Parameter.SET1.MaxRate 0.01...10...150, max.

Mode.Parameter.SET1.MinRate 0.01...25.0...999.9

Parameters for SET: Control parameters, see page 33.

.Dyn: Dynamics, control range in pH, mV (with U and Ipol) or µA (with

Upol). The corresponding unit can be read with .UnitDyn.

.MaxRate: Maximum allowed titration rate in mL/min. Max. means maximum

possible rate with the Exchange Unit in current use.

.MinRate: Minimum titration rate in µL/min.

3.2.2.14. Mode.Parameter.SET1.Stop.Type drift, time

Mode.Parameter.SET1.Stop.Drift 1...20...999

Mode.Parameter.SET1.Stop.Time 0...10...999, inf.

Mode.Parameter.SET1.Stop.StopT 0...99999, OFF

Parameters for SET, KFT: Type and size of the stop criterion of the titration.

.Type: Type of stop criterion after stop drift or switch-off delay time.

.Drift: Stop drift in µL/min. Applies when "drift" has been selected.

.Time: Switch-off delay time in s. Applies when "time" has been selected.

"inf." means infinite.

.StopT: Stop time in s. Applies when "time" has been selected and the value of

.Time is set to "inf.".

3.2.2.15. Mode.Parameter.TitrPara.Direction +, –, auto

Parameters for SET, KFT: Titration direction.

"auto" means the titration direction is determined automatically by the instru-

ment. If 2 EP's have been set in a SET titration, the titration direction is given

by the two EP's. The entry of the titration direction is then invalid.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 209 210

Comments to this Manuals

No comments

Metrohm 758 KFD Titrino User Manual Page 105

Comments to this Manuals

Related products and manuals for Equipment Metrohm 758 KFD Titrino