Metrohm 730 Sample Changer User Manual download pdf (Page 152)

4.10 Remote Control Commands

730 Sample Changer, Detailed Description

149

.Ch.OM "Opening Moves": Begin of start sequence

.Ch.CM "Closing Moves": Begin of final sequence

.E Error: Message with error number (see page 128.)

Format of AutoInfo messages:

(space)!device name"AutoInfo node"

Example: !Changer1".G"

4.10.2.43 Setup.PowerOn $G

Simulation of "power on". The method last used is ready for op-

eration.

4.10.2.44 Setup.Initialize $G

Setup.Initialize.Select param, config, setup,

assembly, all

Setting of default values for the following branches:

param: Method parameters (sets empty method

'∗∗∗∗∗∗∗∗')

config: Configuration, branch &Config

setup: Branch &Setup

assembly: Branch &Assembly

all: All values of the entire tree.

Initialization is triggered with &Setup.Initialize $G.

4.10.2.45 Setup.RamInit $G

Initialization of the entire working memory. All parameters will be

set to default; error messages will be deleted (see page 175).

4.10.2.46 Setup.InstrNo.Value 8 ASCII characters

Device number. Essential for service purposes. The device num-

ber must not be altered.

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 194 195

No comments

Metrohm 730 Sample Changer User Manual Page 152