Metrohm 904 Titrando User Manual download pdf (Page 26)

3.4 Connecting USB devices

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

￭￭￭￭￭￭￭￭

904 Titrando

￭ Connect the Remote Box connection cable to one of the sockets

marked with MSB on the rear of the control instrument.

￭ Start the control software.

Figure 10 Connecting the Remote Box

You can, for example, connect an 849 Level Control (fill level monitoring

in a canister) or a 731 Relay Box (switch box for 230/110 volt alternating

current sockets and low-voltage direct current outlets). The Remote Box

also has an MSB socket at which a further MSB device, e.g. a dosing

device or a stirrer, can be connected.

You will find precise information concerning the pin assignment of the

interface on the Remote Box in the appendix.

3.4 Connecting USB devices

3.4.1 General

The 904 Titrando has two USB connectors (type A sockets) for peripheral

devices with USB interfaces. The Titrando functions as a USB hub (distribu-

tor) no matter how it is operated. If you wish to connect more than two

devices to the USB, you can also use an additional, commercially available

USB hub.

CAUTION

If you operate the 904 Titrando with the aid of the Touch Control, take

care to ensure that the Touch Control is switched off when you set up

or disconnect connections between the various instruments. If you use

a PC software to control the 904 Titrando, you should exit the program

before you set up or disconnect the USB connections.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 57 58

No comments

Metrohm 904 Titrando User Manual Page 26