■■■■■■■■■■■■■■■■■■■■■■
3 Installation
815 Robotic USB Sample Processor XL
■■■■■■■■
29
Mounting the distributor
Figure 19 Mounting the distributor
Proceed as follows:
1
Remove a chain link
■ Remove the clip of the third chain link of the guide chain. Pry out
the clip with a screwdriver on both sides of the chain link, as
shown in the preceding illustration.
2
Insert the distributor
■ Apply strong pressure to insert the 6.1808.170 distributor
(with the tubing connected) into the open chain link.
3
Fix the rinsing tubings
■ Place the rinsing tubings into the guide chain.
3.9 Guide chain for cables and tubing
Tubings and cables can be placed into the guide chain.
You can open the individual chain links with a screwdriver as follows.
1
Open the guide chain
■ Insert a screwdriver into the groove located on the side of a chain
link.
■ Loosen the clip with a forceful leverage movement.
■ Pull the clip out of the chain by hand.
■ Repeat the above actions for each chain link.
Comments to this Manuals